AP1301 Planer DC Mod

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • Bill in Buena Park
    Veteran Member
    • Nov 2007
    • 1867
    • Buena Park, CA
    • CM 21829

    #1

    AP1301 Planer DC Mod

    I'd been mulling over options on how to get 4in DC on my AP1301, which comes with a 2.5in shopvac port (and works very well with the shopvac) - but I wanted to take advantage of the chip separator on my 4in DC line instead of replacing shopvac filter bags.

    I was considering cutting a 4in port in the upper plastic blade cover housing and retrofitting a 4in DC port, but saw a concept of mounting a segment of 4in DC pipe that could be connected to the DC line - so I came up with this retrofit:

    1) Removed the yellow plastic cover attachment at the back;
    2) Cut a segment of DC pipe, and removed a ~2in wide segment from the side of it, to fit over the chip ejection section at the back of the planer
    3) Drilled and fastened some brackets to hold the DC pipe in place
    4) Added some duct tape to seal the small gaps above and below the pipe
    5) PVC-glued some couplers to each side of the pipe
    6) Made a cap-gate to close off one side

    My DC hose plugs into either side, depending on planer orientation and proximity to my DC line. Ran some tests on planing 2x4, and there was sufficient through-put to pull 95+% of the chips. She ain't pretty, but she works, and I like it.

    Pics below - thanks for looking.
    Attached Files
    Last edited by Bill in Buena Park; 07-25-2010, 06:58 PM. Reason: Add link
    Bill in Buena Park
  • toolguy1000
    Veteran Member
    • Mar 2009
    • 1142
    • westchester cnty, ny

    #2
    nicely done. looks like it will enhance the collection at the planer significantly. i'm interested in the connection of the black DC hose to the S&D pipe that comprises the new dust collection hood on the planer. any chance for a few more pics of that?
    there's a solution to every problem.......you just have to be willing to find it.

    Comment

    • Bill in Buena Park
      Veteran Member
      • Nov 2007
      • 1867
      • Buena Park, CA
      • CM 21829

      #3
      Joseph,
      There are some closeup photos in this thread, pg 2. Hose on hose-coupler, forced into segment of S&D pipe that was slit on 3 sides to accommodate.
      Bill in Buena Park

      Comment

      Working...