I'm going to try turning my first bowl, but since I don't have a chuck I'll be using a faceplate with a waste block. Using Titebond II, what is the minimum time you would allow for drying before turning it on the lathe? Directions say 24 hours, but patience isn't one of my better virtues
and the garage is finally warm enough I won't be tempted to wear gloves! Waste block is (previously) glued pine, bowl is of Tipa Colorado, if that matters.
Thanks for all the great info on this site!
and the garage is finally warm enough I won't be tempted to wear gloves! Waste block is (previously) glued pine, bowl is of Tipa Colorado, if that matters.Thanks for all the great info on this site!


Comment