I'd like some input on how you folks hollow small vessels.
Turning goblets, about 1.5" diameter and making the vessel about 1.5-2" deep with straight sides, I'm having issues. Shallow depths are not a problem, it's the getting deep into a small opening that gives me catches.
Following the Sorbey and other videos I use a spindle guage, cutting from the center out on the end grain.
Any suggestions appreciated.
Turning goblets, about 1.5" diameter and making the vessel about 1.5-2" deep with straight sides, I'm having issues. Shallow depths are not a problem, it's the getting deep into a small opening that gives me catches.
Following the Sorbey and other videos I use a spindle guage, cutting from the center out on the end grain.
Any suggestions appreciated.
Comment