A couple of bent laminations

[Jim Boyd]

I like the second better. Not quite as "busy"

[gerti]

Great stuff!

[monte]

Very nice Jim!

[Whaler]

Beautiful work Jim.

[boblon]

Very nice work.

BobL.

[jdoolitt]

Beautiful work Jim. Did you get the technique from a book? Site?

[mater]

Both are very nice Jim. I like the 2nd one also.

[Ken Massingale]

Real nice, Jim.
ken

[Jim Boyd]

quote:Originally posted by jdoolitt

Beautiful work Jim. Did you get the technique from a book? Site?

I saw some pics on another forum of a similar type design. There was a lot of hubub about how to do it and the creator would not come out and say how. Ruffled lots of feathers. I just read all of his posts and pretty much figured it out with some trial and lots of error. A lot of blades died on the previous attempts. Most of the time I can learn a whole lot by keeping my mouth shut and paying attention. Wait! Didn't somebody tell me that when I was a youngun? [:0]

[gerti]

quote:Originally posted by Jim Boyd
I saw some pics on another forum of a similar type design. There was a lot of hubub about how to do it and the creator would not come out and say how. Ruffled lots of feathers. I just read all of his posts and pretty much figured it out with some trial and lots of error. A lot of blades died on the previous attempts. Most of the time I can learn a whole lot by keeping my mouth shut and paying attention. Wait! Didn't somebody tell me that when I was a youngun? [:0]

OK, so don't tell us how...

[Jim Boyd]

quote:Originally posted by gerti

quote:Originally posted by Jim Boyd
Most of the time I can learn a whole lot by keeping my mouth shut and paying attention. Wait! Didn't somebody tell me that when I was a youngun? [:0]

OK, so don't tell us how...

This has a couple more steps than what I used but it will get ya to the same end.
Laminated blanks