Table saw change

[jeepman71]

I broke down and crossed over.

I sold my Cman 21829 and shark gaurd for a fair price and buaght the Rigid R4512. I was able to use the HF cupon bringing the total price to 451.51 tax included so the cost to change was $100.00 bill. I know there are a lot better saws out there but for a good price I get a new saw that has had decent reviews and some mobility with lifetime service for a small additional investment.

A little adjustement to my garage and I will be back in business.

Here's to the old saw and hope I have as much fun with the new.

Jim

[Knottscott]

Congrats on the "alleged" saw.....with some pics it could be verified as an "actual" saw!

[sailor55330]

Gratz on the new saw....allegedly.

If you take your time during set up, I think you'll find it to be a good saw, especially for the price. DAMHIKT.

[jeepman71]

I got a little time to work on the saw yesterday. Got it put together but have not had a chance to do any set up yet.

The two peice rail is going to be a bit finicky, I have a little lip when going from left to right on the right side of the blade. I don't think it is going to be an issue that will cause me to need to spend $150.00 for a Delta fence. Other than that all has went well so far.

My wonderful wife and I hosted about 60 people Saturday for my Dad's 70th birthday party. it was worth the delay, he enjoyed himself. I did find that if we do an 80 for him I need about 1000 mosre sq ft.

Jim