Compressor for veneering

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • asdf
    Forum Newbie
    • Jan 2006
    • 64
    • .

    #1

    Compressor for veneering

    Hi all,

    I recently bought the V2 Plus system from veneer supplies and I need to pick up a compressor to power it. It requires 4.8CFM at 80psi and a 12 gallon tank.

    I'm not looking to break the bank here though. Any recommendations on HF compressors? This one caught my eye and is on sale in the most recent flyer for $119, though it only has a 10 gallon tank.
    http://www.harborfreight.com/cpi/cta...emnumber=90234
    This appears to exceed the CFM requirements and is a good price. And I like that it's oiled so it should be quieter.

    Or this one which has more volume capacity:
    http://www.harborfreight.com/cpi/cta...emnumber=94667
    I'm sure it will go on sale soon.

    Any other suggestions? Maybe a Campbell Hausfeld / Husky? I'm a little hesitant b/c I've seen a couple bad CH reviews; what are your thoughts?

    I hope to be able to use this as a good launching point be able to acquire some air tools (both for general construction and woodworking).

    All your input is appreciated!

    Thanks
  • drumpriest
    Veteran Member
    • Feb 2004
    • 3338
    • Pittsburgh, Pa, USA.
    • Powermatic PM 2000

    #2
    If you are going for a larger compressor, I'd consider getting one large enough to spray finished HVLP style as well. Might as well kill those 2 birds with one stone.
    Keith Z. Leonard
    Go Steelers!

    Comment

    • asdf
      Forum Newbie
      • Jan 2006
      • 64
      • .

      #3
      I agree. What CFM & volume does those systems usually require?

      Any manufacturer/model suggestions?

      Comment

      Working...