Router dilemas

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • viking4949
    Forum Newbie
    • Jan 2008
    • 54
    • Northwest Indiana
    • Craftsman 22811

    #16
    I went with the craftsman kit for a few reasons. The table I have already had a multile drilled adapter plate that would fit the craftsman for sure, not so sure on the hitachi. I also was worried about adjusting the bits on the hitachi when attached to the table. The ability to move the fixed base up and down from the top of the table using the craftsman and a hex key seemed to be a good feature. Finally impatience, I finally had a whole day to play and Sears is only a few miles away. Thank you all for your help.

    Brandon

    Comment

    • Hoover
      Veteran Member
      • Mar 2003
      • 1273
      • USA.

      #17
      Well in my book adjusting the bits on my Hitachi is a non-issue. It will pop out of the table in a few seconds, and replacing bits a piece of cake. Many of the people who responded on this thread recommended Hitachi.
      No good deed goes unpunished

      Comment

      Working...