If so, then this may be perfect for measuring obscure bevels. Will it also allow you to measure a horizontal angle as well?
Where as Pecker says no, I think you can. . .
Find a good SOLID surface (say a table saw) and set your zero for the gauge. Now, put the fence of the miter onto the surface of the table with the arm hanging down and place the gauge on the side of the dangling arm. . .
Enco 12" RT table saw(with router table currently added to right wing), Central Machinary 6" jointer, Delta 16" (17-900) drill press, Ridgid 14" bandsaw, Jet bench top Mortising machine, Porter Cable 6901 series routers (2) and a wide variety of Ryobi 18v tools.
Find a good SOLID surface (say a table saw) and set your zero for the gauge. Now, put the fence of the miter onto the surface of the table with the arm hanging down and place the gauge on the side of the dangling arm. . .
That might just work. If I get one for Christmas like eccentrictinkerer above I'll give it a try.
Comment