Fence stops (yes, also easy, fast and cheap)

[niki]

Good day

I have seen many kinds of stops for the table saw sled fence and the drill press fence but...
I could not find any T-Track here, so I had to make something different...

The stops that I made have some "plus" on the T-Track ones - you can remove them out of the way very easy while the T-Track ones, have to be dragged all the way out unless, it's on hinge but, I don't like hinges because they always have some play.

...To the pics...

Regards
niki

[final_t]

Awsume as always

As usual, make a book!

My two cents, because this has been on my mind:
I know you like to use the super glue a lot, but I would suggest for the butt-end joints ("spread super glue at the center of this piece") to NOT use it there and instead use a typical wood glue. Super glue just doesn't have the kind of lateral strength you're expecting. Plus it's expensive!

[niki]

Thank you Final t

You are correct.
My excuse is (because I don't have reasons) that, there is no any structural stress on this "piece", it's just a guide to show the distance on the measuring tape, the stop will work also without this piece.

Regards
niki