Mating the Incra V27 w/Hartville x-cut fence
A few weeks ago there was alot of discussion about the Incra V27 deals going on. In one of those discussions I posted a pic of my V27 and Hartville fence, which fostered a question about the wood backer I had used to mount the crosscut fence. I mentioned that the holes on the Incra and the t-slots on the Hartville fence don't mate up very well, so I used a piece of hardboard as a go between.....that turns to be incorrect information, and I apologize to anyone who used that erroneous info to influence a decision.
I happened to look at my V27 yesterday and noticed that the wood backer is no longer mounted, and I remembered that it was the size of the knobs I used that interferred with using the stock Incra holes, not an incompability issue....sorry.
(the pic in question is shown below)
I happened to look at my V27 yesterday and noticed that the wood backer is no longer mounted, and I remembered that it was the size of the knobs I used that interferred with using the stock Incra holes, not an incompability issue....sorry.
(the pic in question is shown below)
