Does anyone have experience with Shark saw blades?

Collapse
This topic is closed.
X
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • vanguard
    Established Member
    • Jul 2005
    • 287
    • Brighton, MI, USA.
    • Ridgid TS2400SL
    #1

    Does anyone have experience with Shark saw blades?

    I've been looking for a 9" blade for my '60s era RAS. I came a cross an eBay auction for these blades and when googling for more info I found them on Amazon as well. Does anyone have experience with this manufacturer? Would these be suitable for a RAS?

    http://www.amazon.com/Shark-Pro-Carb.../dp/B000JO8IGK

    Browsing the Amazon storefront for tritek also shows a 9" blade for table saws as well.
    Last edited by vanguard; 01-18-2007, 09:09 AM.
    Tags: None
    • LinuxRandal
      Veteran Member
      • Feb 2005
      • 4890
      • Independence, MO, USA.
      • bt3100
      #2
      Over on another board, someone ordered some blades throught a reseller, via amazon. They said they were out of stock and were trying to substitute these. No one on the group had ever heard of or used these blades, so they don't seem to have a track record.

      How are you going to use your ras? Because if you are planning on EVER having the possibility of ripping on it, the cheaper blade that is recommended, is the LU83R0 (08,09,10) series. It runs a close second to the Forrest WWI that is available ONLY through Charles at Forrest (Mr. Sawdust WWI).
      She couldn't tell the difference between the escape pod, and the bathroom. We had to go back for her.........................Twice.

        Comment

        • vanguard
          Established Member
          • Jul 2005
          • 287
          • Brighton, MI, USA.
          • Ridgid TS2400SL
          #3
          I'll have to look for the LU83R0. The Forrest blade pricing is awfully steep for me. I've got an 8" Irwin Miter blade on it now, but I'd like the extra depth. I was mitering some 2x8s for some exterior trim and was having issues with the bottom of the motor running into the wood.

            Comment

            Previous template Next
            Working...