Anyone know where would be a good place to buy one from for an old Delta Rockwell lathe?
Jeff
Jeff
-
-
not sure where to look, but what you're looking for is called a "duplicator". That in itself may help your search.Mike
Lakota's Dad
If at first you don't succeed, deny you were trying in the first place. -
have you thought about doing a homeade verson? attach a following devise to a parting tool to mark the depths (following the origioal turning), and do the rest by hand and eye. would be a lot cheaper, and then you could still say it was turned by hand, from start to finish.AlexComment
Comment