OK, so here I am cutting slots in 1/8" aluminum angles to attach my accessory table. I'm using my old Dremel 395 which I've had for years but never used much. By the time I wore through every cutting wheel I had I managed to cut a grand total of 1.5 of 4 needed slots.
Anyway, the point of this thread is that the tool got really hot. Not burn you hot but pretty close. After sitting 5 minutes its still most warm. Is this normal or is the Dremel toast?
If toast, please recommend replacement model.
Thanks!
Tom
Anyway, the point of this thread is that the tool got really hot. Not burn you hot but pretty close. After sitting 5 minutes its still most warm. Is this normal or is the Dremel toast?
If toast, please recommend replacement model.
Thanks!
Tom