My press started a racket yesterday while I was sanding.
I found this on the website:
10" & 12" Variable Speed Drill Press
Problem: Motor pulley wobbles excessively
Solution: The inner sleeve of the upper half of the pulley may have become dislodged. It can be re-inserted and secured with a set screw through a threaded hole
Has anybody done this yet or is there another cure?
Thanks
Frank
I found this on the website:
10" & 12" Variable Speed Drill Press
Problem: Motor pulley wobbles excessively
Solution: The inner sleeve of the upper half of the pulley may have become dislodged. It can be re-inserted and secured with a set screw through a threaded hole
Has anybody done this yet or is there another cure?
Thanks
Frank
Comment