New from Microjig - Zeroplay bars

[RodKirby]

Very interesting...

http://www.microjig.com/zeroplay.htm

This is obviously "hot off the presses". I got the link thru an Oz site - it doesn't show up on the microjig site.

Check out the setup movie - I'm getting 2, whatever they cost - when I can find somewhere to buy them

[sparkeyjames]

I like it. Simple easy to adjust. Looks like it will adjust to just about any slot even the over sized sloppy ones on cheaper saws.

[MilDoc]

Interesting that if you go to MicroJig's home page you can't find any information on the guide bars.

[Uncle Cracker]

The company is not far away. I may just stop by and ask them.

[FL Buckeye]

MicroJig had these back around 2003/2004 timeframe. Must be discontinued now. UC, ask them if they have any NOS they want to sell. Maybe they sent them to Oz.

[just started]

The webpage is dated 2007 so I would expect it's discontinued now and someone forgot to remove the page when they removed the link from the home page of the site.

[RodKirby]

The webpage is dated 2007 so I would expect it's discontinued now and someone forgot to remove the page when they removed the link from the home page of the site.

Dang! Just my luck