Pimp My Shop [update]

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • Hoakie
    Established Member
    • Feb 2007
    • 382
    • Iowa
    • Craftsman 21829

    Pimp My Shop [update]

    Its been a while since I started my shop conversion project. In my original post Pimp My Shop, I received a lot of advice on ways to improve the work space. I have subsequently done quite a bit of work and added some major equipment. Here is what I've done.
    • Removed All the kids toys and other storage items
    • Cleaned out junk tools/other crap
    • Added Craftsman 21829 TS
    • Added Jet 12" BS
    • Added HF 2HP DC + Wynn Canister
    • Built assembly table
    • Built cutoff storage
    • Replaced two small fluorescent lights and added 4 additional larger lights (6 total)
    • Added 3x4 outlet overhead boxes (re-ran wire/conduit)
    • Added 4x2 outlet boxes on wall where DP table and DC are located
    • Removed router table from work bench (see future plans)
    • Lowered workbenches from 38" to 36"
    • Rearranged some of the tools to take advantage of new electrical configuration.
    Plans for Future:
    • Close off Water Heater, and furnace
    • Run DC duct work
    • Build Router Table
    • Build cabinets under work benches
    • Build better stands for DP, sander and Scroll saw
    • Add BIL's Planer and Jointer








    Last edited by Hoakie; 09-05-2007, 07:07 AM.
    John
    To invent, you need a good imagination and a pile of junk. ~ Edison
  • RodKirby
    Veteran Member
    • Dec 2002
    • 3136
    • Melbourne, Victoria, Australia.
    • Mao Shan TSC-10RAS

    #2
    Lookin' good
    Downunder ... 1" = 25.4mm

    Comment

    • gad5264
      Veteran Member
      • Aug 2005
      • 1407
      • Columbus, Ohio, USA
      • BT3000/BT3100NIB

      #3
      I like the adjustable height assembly table. Is that ala Rod Kirby?
      Grant
      "GO Buckeyes"

      My projects: http://community.webshots.com/user/gad5264

      Comment

      • Hoakie
        Established Member
        • Feb 2007
        • 382
        • Iowa
        • Craftsman 21829

        #4
        Originally posted by gad5264
        I like the adjustable height assembly table. Is that ala Rod Kirby?

        Yes Sir. I have better pictures of it here
        John
        To invent, you need a good imagination and a pile of junk. ~ Edison

        Comment

        • ironhat
          Veteran Member
          • Aug 2004
          • 2553
          • Chambersburg, PA (South-central).
          • Ridgid 3650 (can I still play here?)

          #5
          It's really shaping up for you. GOod work!
          Blessings,
          Chiz

          Comment

          • footprintsinconc
            Veteran Member
            • Nov 2006
            • 1759
            • Roseville (Sacramento), CA
            • BT3100

            #6
            nice layout! nice additions.

            this reminds me that i have to clean my garage
            _________________________
            omar

            Comment

            Working...