I have what I have done design wise uploaded to the 3D Warehouse...
Like I tried to explain in the description. I am planning on attaching the cabinet itself to the risers on the mobile base (4x4 cutoffs planed to the minimum thickness that will allow the bottom of the cabinet to clear the foot of the drill press and any fasteners) using simple, heavy duty draw catches that can be sourced at any hardware store. I did not model them, I was being lazy...
I also did not model the drawer boxes, but instead left that for you to do to accomodate whatever hardware you were going to use. I am seriously thinking about just using wooden slides for mine for simplicity sake...
And you may notice, I changed my mind of drawer / open storage orientation. I felt I needed to have the more frequently used stuff up high. So the open slots where the hand drills go, gets put down low...
Cabinet and Mobile Base Only.
Drill Press, table, cabinet and mobile base, whole enchilada...
Like I tried to explain in the description. I am planning on attaching the cabinet itself to the risers on the mobile base (4x4 cutoffs planed to the minimum thickness that will allow the bottom of the cabinet to clear the foot of the drill press and any fasteners) using simple, heavy duty draw catches that can be sourced at any hardware store. I did not model them, I was being lazy...
I also did not model the drawer boxes, but instead left that for you to do to accomodate whatever hardware you were going to use. I am seriously thinking about just using wooden slides for mine for simplicity sake...
And you may notice, I changed my mind of drawer / open storage orientation. I felt I needed to have the more frequently used stuff up high. So the open slots where the hand drills go, gets put down low...
Cabinet and Mobile Base Only.
Drill Press, table, cabinet and mobile base, whole enchilada...