new yankee work table

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • bebop
    Forum Newbie
    • Feb 2006
    • 13
    • Chantilly, VA
    • bt3100 of course :)

    #1

    new yankee work table

    Anybody happen to see the new yankee episode with his work table and clamp cart?

    I'm trying to remember whether the stressed panel system he used for the top had 1/4" plywood on the underside of the panel as well as the top. I haven't built anything that way and I'm not sure if a single sheet on top would be strong enough, but I could build the table larger if it were.

    Thanks in advance!
  • jonmulzer
    Senior Member
    • Dec 2007
    • 946
    • Indianapolis, IN

    #2
    The stressed panel itself used 1/4" plywood top and bottom, but then had a replaceable work surface made of 3/4" MDF if I remember correctly. The 1/4" plywood was just the skin of the supporting panel and not meant to endure workshop use.
    "A fine beer may be judged with just one sip, but it is better to be thoroughly sure"

    Comment

    • bebop
      Forum Newbie
      • Feb 2006
      • 13
      • Chantilly, VA
      • bt3100 of course :)

      #3
      aha, thank you sir. I remembered about the mdf, but couldn't figure out the underside of the panel from the photos and sketch.

      Comment

      • JimD
        Veteran Member
        • Feb 2003
        • 4187
        • Lexington, SC.

        #4
        I made a table/outfeed table using the same general idea as Norms. I used 3/4 plywood for the top of the stressed panel and then put 1/4 plywood (soon to be replaced by mdf) as the disposable surface. 1/4 is cheaper to replace than 3/4 (but does decide to stick up above the solid wood edging occasionally).

        Jim

        Comment

        Working...