Do I Need More Support?

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • crokett
    The Full Monte
    • Jan 2003
    • 10627
    • Mebane, NC, USA.
    • Ryobi BT3000

    #1

    Do I Need More Support?

    For the kitchen bench - the seats are 20" deep. The rear piece fixed is 7", hinged section is 13". The rear is supported around the edges and has 6" wide supports along the span. At the corner of the L, the hinged seat is mitred, the rear is not. Do I need any support on that mitre? I'd like to leave it a clear span so as not to lose storage.

    The original bench the hinged seat was supported along the front edge and by the hinges, but there was not a mitred corner.
    David

    The chief cause of failure in this life is giving up what you want most for what you want at the moment.
  • MikeMcCoy
    Senior Member
    • Nov 2004
    • 790
    • Moncks Corner, SC, USA.
    • Delta Contractor Saw

    #2
    Just a thought but have you considered making the corner a half lap miter?

    Comment

    • crokett
      The Full Monte
      • Jan 2003
      • 10627
      • Mebane, NC, USA.
      • Ryobi BT3000

      #3
      Originally posted by MikeMcCoy
      Just a thought but have you considered making the corner a half lap miter?
      Too late - the hinged seats are already cut. Have to do some final sanding and paint before I install them. I could attach a cleat underneath one side though.
      David

      The chief cause of failure in this life is giving up what you want most for what you want at the moment.

      Comment

      Working...