Flattening a Picture

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • crokett
    The Full Monte
    • Jan 2003
    • 10627
    • Mebane, NC, USA.
    • Ryobi BT3000

    #1

    Flattening a Picture

    My wife bought a picture this summer that I am framing for my inlaws for Christmas. Unfortunately it was not packed all that well in the tube and the roll got squished. I've unrolled it but it has fold marks on it. Is there a way to flatten it again? Maybe low heat on an iron? I've thought about gluing it to the backer on the picture frame but not sure I can keep it flat enough.
    David

    The chief cause of failure in this life is giving up what you want most for what you want at the moment.
  • jziegler
    Veteran Member
    • Aug 2005
    • 1149
    • Salem, NJ, USA.
    • Ryobi BT3100

    #2
    What size is the picture?

    Gluing it to a backer might work, but probably not the one that came with the frame. Some people even use foam core to mount photos, using spray adhesive.

    If it's small enough, spread it out and place it under a stack of books (the heaviest you can find) for a few days. If it's too big for that, a sheet of plywood with books (or paint cans) on top.

    Jim

    Comment

    • crokett
      The Full Monte
      • Jan 2003
      • 10627
      • Mebane, NC, USA.
      • Ryobi BT3000

      #3
      The picture is a 16x20. Right now it is under the glass that will go in the frame, but not with any weight on it. I was hoping I could mist the back with water or something to get it to relax, then put it under the glass to hold it flat.
      David

      The chief cause of failure in this life is giving up what you want most for what you want at the moment.

      Comment

      • jziegler
        Veteran Member
        • Aug 2005
        • 1149
        • Salem, NJ, USA.
        • Ryobi BT3100

        #4
        That might work.

        I have a couple posters that I bought on a trip to France that are framed. Of course, for the trip back home they got crushed a little when rolled up. I think that we used weight alone to flatten them out, but I'm not quite sure anymore (probably was 4 years ago). You can still see that they had been faloded a bit, but they look pretty good overall.

        Jim

        Comment

        • BTC3K
          Forum Newbie
          • Apr 2007
          • 16

          #5
          Paper Type?

          Depends On What It Is.

          Comment

          • crokett
            The Full Monte
            • Jan 2003
            • 10627
            • Mebane, NC, USA.
            • Ryobi BT3000

            #6
            Originally posted by BTC3K
            Depends On What It Is.

            Nothing special - just poster-type paper
            David

            The chief cause of failure in this life is giving up what you want most for what you want at the moment.

            Comment

            • BTC3K
              Forum Newbie
              • Apr 2007
              • 16

              #7
              Ok...

              Paper Is Fibrous...you Can Relax Cheap Paper With Steam...very Low Heat. Depends On The Wrinkles Severity. If You Iron It, Do So Slowly And Use A Spray Bottle And A Piece Of Harder Paper Like Backerboard From A Notepad...its Called Chip Board. I Don't Know About The Color-fastness But You Can Try Before With Paper Like It Beforehand. Also Talk To A Frameshop And See What They Say But Don't Fall For The Money Angle They Will Try On You. Take Your Time...

              Comment

              Working...