I am prepping some cabinet doors to apply finish. Here is what I am doing and I am wondering if I am sanding too much?
1. Panels are run through the planer with 1/64" taken on the last pass.
2. Raised the panels on the router.
3. Sanding using ROS with 150, then 220, then 320 grit.
4. Finish sander with 400 grit.
The panels look really nice with a mirror like finish. I have applied Watco Danish oil to one panel and it absorbs the oil OK. I will topcoat with Resisthane Plus (Satin).
So I would appreciate some advice on my preparation process. I have a lot of these to do and don't want to waste time over-sanding. Thanks.
1. Panels are run through the planer with 1/64" taken on the last pass.
2. Raised the panels on the router.
3. Sanding using ROS with 150, then 220, then 320 grit.
4. Finish sander with 400 grit.
The panels look really nice with a mirror like finish. I have applied Watco Danish oil to one panel and it absorbs the oil OK. I will topcoat with Resisthane Plus (Satin).
So I would appreciate some advice on my preparation process. I have a lot of these to do and don't want to waste time over-sanding. Thanks.
Comment