Got lots of great suggestions on my door trim and things started going so well that now I get to start on the baseboards. I started by just laying a piece out and nailing it to the bottom plate then nailing at each stud to get it flush to the wall but the walls are far from square and straight. This leaves gaps between the wall and the trim between some of the studs. Is there anything that I could do to close the gap or would it just cause problems with the trim not looking straight?
Was also wondering if butt joints are the norm or do people use mitres where two pieces meet along a long wall? Should I end a piece at a stud center in order to start the next piece on a stud?
Thanks
Steve
Was also wondering if butt joints are the norm or do people use mitres where two pieces meet along a long wall? Should I end a piece at a stud center in order to start the next piece on a stud?
Thanks
Steve
Comment