Installing Piano Hinge

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • tmaceroli
    Established Member
    • Mar 2004
    • 133
    • Forked River, New Jersey, USA.
    • Ryobi BT3100

    #1

    Installing Piano Hinge

    I installed a piano hinge on a full-overlay cabinet door. I routed out a mortise for the hinge, no problem there. I placed the face frame and the door frame side by side, and put a spacer in top and bottom so the two parts were the same distance apart, and then clamped down the two frames to keep the alignment. I made sure the hinge was square when I made the pilot holes.

    After I installed the hinge and closed the door, the frame and the door were not aligned properly, ie the were not square to each other. So the door frame on the side opposite the hinge extends past the face frame. It would be OK, I guess if it was straight, but it isn't. It extends more at the top than at the bottom, so I can't just plane down the door stile to make it fit properly. Ugh.

    Two questions:

    1) Where did I go wrong?

    2) More importantly, what's the best way to fix it?

    Thanks,
    Tony
    Tony

    "Nothing would be done at all if a man waited until he could do it so well that no one could find fault with it."
    - Cardinal Newman
  • LarryG
    The Full Monte
    • May 2004
    • 6693
    • Off The Back
    • Powermatic PM2000, BT3100-1

    #2
    First, we need to know ...

    Not sure where you went wrong. Have you verified that the cabinet carcase is square? And that the door is square? Finally, by how much is the door misaligned/overlapping?
    Larry

    Comment

    • tmaceroli
      Established Member
      • Mar 2004
      • 133
      • Forked River, New Jersey, USA.
      • Ryobi BT3100

      #3
      The door and face frame are square. I think where I went wrong was that I made sure the hinge was square to one door, and the did not check the other. I took one side apart and filled in the holes with wood filler. Then I laid out the frame and door again, so the hinged sides were butted up against one another, with a small spacer. Then I measured, top and bottom, from the outer stile on the frame to outer stile on the door, and made sure those measurements were the same. Then I clamped the two frames to the bench. Since the hinge was already installed on the face frame, I made pilot holes for the door frame, and screwed down the hinge. Voila! The door and face frame were square, and when closed, everything fit much better.

      There is still a little overlap of the unhinged sode of the door on the face frame, so I didn't get this perfect, but it's straight and the overlap is the same 1/16" all the way along the edge.

      I would like to do a better job next time, so how do you lay out a piano hinge properly?
      Tony

      "Nothing would be done at all if a man waited until he could do it so well that no one could find fault with it."
      - Cardinal Newman

      Comment

      Working...