SOLD.
Just when I got the whole thing out of the box and modified, Ive upgraded.
Looking to sell it off as a unit, locally around lower NY/upper NJ state area.
The table has rail extensions on each side, for over 32 in right rip, and like 18 left.
Machined my own rail extension hardware, out of 1"4 hot rolled steel, 5/16" bolts and 32 TNuts. Those leg supports aren't even needed, but I tend to overbuild everything.
Extended fence faces are 1.5" thick of poplar, trued on the jointer, then waxed finished.
Modified to 4" high with another extra BT fence extrusion to double the height.
Extended fence face is 3.5" high and 36" long.
Everything is dead on accurate.
The SMT on the right side have been shortened to allow the fence to pass, but still have plenty of travel for end routing.
Ill throw in the Ryobi router with a variable speed controller.
And of coarse there's the Herc u lift plus, which is wonderful.
Have not yet thrown out the box so it can be packaged again and we can even speak about local delivery.
Motor has quite little time on it, I seem to have enjoyed working on improving the table rather than actually using it.
Just when I got the whole thing out of the box and modified, Ive upgraded.
Looking to sell it off as a unit, locally around lower NY/upper NJ state area.
The table has rail extensions on each side, for over 32 in right rip, and like 18 left.
Machined my own rail extension hardware, out of 1"4 hot rolled steel, 5/16" bolts and 32 TNuts. Those leg supports aren't even needed, but I tend to overbuild everything.
Extended fence faces are 1.5" thick of poplar, trued on the jointer, then waxed finished.
Modified to 4" high with another extra BT fence extrusion to double the height.
Extended fence face is 3.5" high and 36" long.
Everything is dead on accurate.
The SMT on the right side have been shortened to allow the fence to pass, but still have plenty of travel for end routing.
Ill throw in the Ryobi router with a variable speed controller.
And of coarse there's the Herc u lift plus, which is wonderful.
Have not yet thrown out the box so it can be packaged again and we can even speak about local delivery.
Motor has quite little time on it, I seem to have enjoyed working on improving the table rather than actually using it.
Comment