Tweet
I'm parting out my Craftsman version of the BT3000. I got it in 01. All parts are in good condition. The saw wasn't abused. I've upgraded to a
cabinet saw and need to make a few bucks back. I think I'll ship everything FedEx Ground since that's usually the cheapest. I'll compare prices
for FedEx and USPS to keep shipping the cheapest. If you want to know how much shipping will be my zip is 23430.
Here's the list
-Rip Fence $40
-Acc Table $35 (Sold pending payment)
-Sliding Table $40
-Dado and thin kerf ZCTPs (used) $10
-Factory Guard and riving knife $12
-Motor $60
-Open leg stand $whatever
-Full Silver Rails $50
- Wrenches $5 ( I may have 2 sets)
- all 4 factory rail locking levers $5
-Any other parts you want make an offer. Internals, switch, ect...
I'm only going to ship one a week on Fridays. I don't have the time to run out during the week.
cabinet saw and need to make a few bucks back. I think I'll ship everything FedEx Ground since that's usually the cheapest. I'll compare prices
for FedEx and USPS to keep shipping the cheapest. If you want to know how much shipping will be my zip is 23430.
Here's the list
-Rip Fence $40
-Acc Table $35 (Sold pending payment)
-Sliding Table $40
-Dado and thin kerf ZCTPs (used) $10
-Factory Guard and riving knife $12
-Motor $60
-Open leg stand $whatever
-Full Silver Rails $50
- Wrenches $5 ( I may have 2 sets)
- all 4 factory rail locking levers $5
-Any other parts you want make an offer. Internals, switch, ect...
I'm only going to ship one a week on Fridays. I don't have the time to run out during the week.
Attached Files
Comment