Ryobi RE600 base plate needed

[cpmoore]

I have spent countless hours searching the internet for a place to buy an original base plate for a RE600 Ryobi router I recently bought used along with a table in which it was mounted. Apparently it is no longer made however, I would like to find a base plate so I can use it outside the table and with guides. The Ryobi web site is of little value. Any suggestions??

Regards,
Patrick

[RayintheUK]

I used to have an RE601E which looks identical. The base was off when it sheared the spindle lock, so it was still hanging up in my router cupboard. It's 166mm (a hair over 6.5") in diameter and is held to the base by four screws.

If you have no other luck getting one, PM me your postal address and I'll send it. It would be better to wait until the Christmas postal mayhem dies down, though.

Ray.