Mobile Planer Cart

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • LarryG
    The Full Monte
    • May 2004
    • 6693
    • Off The Back
    • Powermatic PM2000, BT3100-1

    #16
    Sounds about right, Loring. My planer currently sits on my router table (the ex-Otter "Ryoborghini") which is about 38" high ... plus the 3/4" MDF baseplate I made for the planer ... plus another ~3" to get up to the infeed/outfeed table level ... near enough 42" all told, and I figure it's just about one foot too high.

    I'm six feet even and when standing erect with my arms relaxed at my sides, my fingertips just brush the top of a 30" high table or counter. So for me I think anything in the 30" - 32" range would be ideal. I might go slightly higher, say up to around 34", if that height would play nice with other worksurfaces that could be used as infeed/outfeed extensions for really long stock.
    Larry

    Comment

    • atgcpaul
      Veteran Member
      • Aug 2003
      • 4055
      • Maryland
      • Grizzly 1023SLX

      #17
      Wow! Nice use of "scrap"!

      Comment

      • Brian G
        Senior Member
        • Jun 2003
        • 993
        • Bloomington, Minnesota.
        • G0899

        #18
        The infeed/outfeed of my setup is at 39". I'm 6'2", and the 39" is about 2" higher than what I consider my ideal working height for most things. I also wanted the planer table to be higher than the tallest surface in my shop, so that I could roll the planer anywhere and face any direction and not have to be concerned about boards running into something.

        Surfaces in the 32" range are just a little low for me. I end up hunched over and then my lower back and upper shoulders ache.
        Brian

        Comment

        Working...