My wife wants me to make a couple of custom frames. I have not made any since getting my new TS, which has been quite a while. I finally got in some shop time today (it's been months), so I made these jigs, next comes the frames themselves.
The sliding miter table jig uses 2 steel Rockler rails in the miter slots, what I have left to do on it is I'll put in some threaded inserts on the face of the triangle for extension fences for stop blocks. I didn't have any inserts handy, the triangle is removable, held in from underneath by 4 screws.
The spline miter jig is attached to a box that slides over the rip fence, you cannot see it in this picture, but it's a simple enough design.
The sliding miter table jig uses 2 steel Rockler rails in the miter slots, what I have left to do on it is I'll put in some threaded inserts on the face of the triangle for extension fences for stop blocks. I didn't have any inserts handy, the triangle is removable, held in from underneath by 4 screws.
The spline miter jig is attached to a box that slides over the rip fence, you cannot see it in this picture, but it's a simple enough design.
Comment