Thanks to all for the kind words. Seems everyone liked the legs so here is how I made them they were really quiet easy to make. First I started with a 2 3/8" x 2 3/8" glue up squared up on the jointer and cut to length, then I laid out and made the mortises. Then I made the profile on the top outside corners on the shaper table using my raised panel bit. With those two steps completed I made a curved template from some scrap, then I cut the curve on one side of each leg with the band saw double faced taped the offcuts back on, then cut the other curve. After all the legs were cut I cleaned up the saw marks with a spoke shave and then sanded them smooth.
As for the top it is not book matched, it's 1/4" walnut ply left over from another project laminated to a piece of 1/2" birch. All the walnut used on the table was scrap from another project.
Comment