Well, its finally done (almost). I've been working on this project on and off for almost a year. It's definitely not perfect, but all in all I'm happy how it turned out. As you can see from the pics, LOML is already putting it to good use. The only part remaining is a top cap, but that may have to wait until I get a router table build that can handle the thumbnail bit I bought for the profile (its too big for my BT3). Next project: install baseboards throughout the house!
Here's a close-up of the doors. The one on the right was the one that I posted about over the weekend, where I drilled the hinge mounts on the front instead of the back. I decided the safest bet was to route out an opening in the back, flip the panel and then flip the door. The finish isn't perfect, but it turned out fine, thanks to everyone's suggestions and help.
Here's a close-up of the doors. The one on the right was the one that I posted about over the weekend, where I drilled the hinge mounts on the front instead of the back. I decided the safest bet was to route out an opening in the back, flip the panel and then flip the door. The finish isn't perfect, but it turned out fine, thanks to everyone's suggestions and help.
Comment