My last Thread got corrupted by the DB problem, so I kindly asked Sam to remove it. Now I'm reposting this thread.
For those who didn't read the first one, here is a summary:
What- Portable out feed table made with 80/20 extruded aluminum profiles.
Specs - Top : red oak 24 1/2" x 11" (attached to rails with t-nuts)
Frame: aluminum profiles that attach to the rear rail w/ t-nuts )
Legs: HWM w/ leveling feet
Features:
options: SMT adapter**
**( not made yet, but have mock up pic, the mahogany board in the pic represents the SMT and the cardboard represents the adapter. The adapter is secured with a profile attached to the center of the top and the right side rail via t-nuts)
Thanks to everyone that responded to the other post your feedback is much appreciated.
UPDATE- I added some finishing touches to it like a wipe down with Old English red oil, a stretcher between the legs ( adjustable ), wooden end caps, and rubber pads on the ends touching the rear rail. Once mounted and adjusted it can be put on or removed in less than a minute. Here are some updated picks with it attached to saw :




For those who didn't read the first one, here is a summary:
What- Portable out feed table made with 80/20 extruded aluminum profiles.
Specs - Top : red oak 24 1/2" x 11" (attached to rails with t-nuts)
Frame: aluminum profiles that attach to the rear rail w/ t-nuts )
Legs: HWM w/ leveling feet
Features:
- can be moved anywhere along rear rail
- can be made wide or narrow
- level with height of the main saw table
- easily replaceable top
options: SMT adapter**
**( not made yet, but have mock up pic, the mahogany board in the pic represents the SMT and the cardboard represents the adapter. The adapter is secured with a profile attached to the center of the top and the right side rail via t-nuts)
Thanks to everyone that responded to the other post your feedback is much appreciated.
UPDATE- I added some finishing touches to it like a wipe down with Old English red oil, a stretcher between the legs ( adjustable ), wooden end caps, and rubber pads on the ends touching the rear rail. Once mounted and adjusted it can be put on or removed in less than a minute. Here are some updated picks with it attached to saw :

(another profile mounted to legs with t-nuts, so stretcher can be adjusted to size of table.) Thanks.
Comment