Good Morning, Hope your Xmas was great.
I'm still getting set up but have a question about miter slots and sleds. I have the Craftsman clone and the router aux table has 2 miter slots in it. Are these accurate if using a xcut sled on them - one sided support not straddling he blade?.
I have also seen xcut sleds that only have 1 miter slot, pros and cons. And when I get my left and right aux tables done I do want miter slots in them. My question here is with to 2 slots straddling the blade, whats a good distance between them to run a xcut sled?
Glenn
I'm still getting set up but have a question about miter slots and sleds. I have the Craftsman clone and the router aux table has 2 miter slots in it. Are these accurate if using a xcut sled on them - one sided support not straddling he blade?.
I have also seen xcut sleds that only have 1 miter slot, pros and cons. And when I get my left and right aux tables done I do want miter slots in them. My question here is with to 2 slots straddling the blade, whats a good distance between them to run a xcut sled?
Glenn
Comment