Replacing Shims

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • Boomer_01
    Forum Newbie
    • Feb 2006
    • 79

    #1

    Replacing Shims

    After 10+ years of use I have to replace the shims on my BT3000 . I have ordered the parts from M&D Mower and they should deliver before the weekend.

    Question, from the current parts diagram it appears that the shims may have been redesigned. They appear as flats not the angled type of shims that are on my saw. Is this correct? If so, do they install differently from the original angle style shims?

    Any help would be appreciated.


    Thanks,
    Boomer
  • Tom Miller
    Veteran Member
    • Mar 2003
    • 2507
    • Twin Cities, MN
    • BT3000 - Cuttin' it old school

    #2
    Two things to keep in mind:

    1. The shims for the BT3100 are a redesign of the ones for the BT3000. I think they can be made to work with the BT3000.

    2. The BT3000 uses two sets of shims, IIRC, to cover the three surfaces of the mounting bracket. One in the set is flat (I think this goes in back, as you face the side of your saw), and the other has a 90 degree bend to cover two surfaces.

    Regards,
    Tom

    Comment

    • Boomer_01
      Forum Newbie
      • Feb 2006
      • 79

      #3
      Tom,
      Thanks for the info. I guess I should expect to receive shims similar to the ones that failed. Glad to know that.



      Boomer

      Comment

      • Black wallnut
        cycling to health
        • Jan 2003
        • 5513
        • Ellensburg, Wa, USA.
        • BT3k 1999

        #4
        Boomer,
        As Tom mentioned the BT3100 uses an updated shim design. If you order new style shims you will also have to replace a few other parts. Several forum members have fixed their saws by upgrading. If you want to replace the shims with the old type http://www.bt3central.com/showthread.php?t=5944

        may help you.
        Donate to my Tour de Cure


        marK in WA and Ryobi Fanatic Association State President ©

        Head servant of the forum

        ©

        Comment

        • Boomer_01
          Forum Newbie
          • Feb 2006
          • 79

          #5
          I am printing your post as we speak. I guess I will just have to wait and see which shims I receive with my order. They are supposed to be for the BT3000 so I am hoping I will get everything I need. I found the problem while inspecting the saw before beginning a new Shaker style Jelly Cabinet. All my lumber is rough sized and the cabinet sides are jointed and edge glued. My blades chisels and planer irons are at the sharpening service.....so by the weekend I will be set to go....if I have a table saw.....LOL.

          Walnut the article was a big help ... thanks for taking the time to put it together.


          Regards,
          Boomer

          Comment

          Working...