Forrest Woodworker II $74.99

[Stormbringer]

Forrest Woodworker II

[Stormbringer]

Now down to $67.68

Link

[Jeffrey Schronce]

.100 Kerf is $67.68
.125 Kerf is $64.30

[mn95616]

Thanks. I just purchased the one with 0.125 kerf. Ironically - I don't have a table saw yet. :P

[Stormbringer]

Thanks. I just purchased the one with 0.125 kerf. Ironically - I don't have a table saw yet. :P

Ahhh... very clever. Make the smaller purchase to justify a larger one.


Some more tips:

Buy some biscuits
Buy some pocket hole screws
Buy some 4" blast gates
Buy some jointer and planer replacement knives.
Buy an aftermarket drill press table
Buy some 14" bandsaw blades
Buy some router bits
Buy some mortising chisels


Regards!
Greg

[hermit]

I need some advice on this. I ordered the 30 tooth for $59 last week, but the ship date is delayed until October. Should I cancel that, and order this one instead?? If so should I go thin kerf or regular in you guys' opinion. I have the Craftsman 22124 saw.

Todd

Update: Guess it doesn't matter. Its up to 82.99 now

[Knottscott]

I need some advice on this. I ordered the 30 tooth for $59 last week, but the ship date is delayed until October. Should I cancel that, and order this one instead?? If so should I go thin kerf or regular in you guys' opinion. I have the Craftsman 22124 saw.

Todd

Update: Guess it doesn't matter. Its up to 82.99 now

Hi Todd - I think I'd hang on to that 30T...it may ship sooner than their estimate, as is often the case. Of the 36 blades I've tried, the 30T WWII TK is my favorite "go to" blade on my 22124. It's a heck of a blade that hogs through material pretty effortlessly and leaves a surprisingly clean cut....can't think of anything more I could ask from one blade. Lately I've been recommending skipping the 40T and going for the one you've got on order.

[hermit]

Sounds good Dustmight, thanks. I ordered it based on your review and comments anyway. I'll just wait ....... anxiously!

Todd