Plastic laminate sheets?

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • chopnhack
    Veteran Member
    • Oct 2006
    • 3779
    • Florida
    • Ryobi BT3100

    #1

    Plastic laminate sheets?

    How long can you keep plastic laminate rolled up? I scored some nice horizontal grade plastic laminate from a commercial shop selling 4x8 sheets for $15 a piece. Of course I snapped up 3 with no where to store them, but I thought it was a good deal. The stuff is pretty thick and stiff. Any ideas on detrimental effects of leaving it coiled for too long in a hot and humid garage??
    I think in straight lines, but dream in curves
  • Mr__Bill
    Veteran Member
    • May 2007
    • 2096
    • Tacoma, WA
    • BT3000

    #2
    I had two pieces of blue laminate, each 30" by 12' rolled to about 24" in diameter. Used the first and darn near lost a finger when I cut the twine on the roll. The second sat for a winter and spring and when the twine was cut it just sat there still rolled up. It was stored in an unheated space with temps down to below zero. I carefully unrolled it in the sun with some weight on it for several days and when the weight was removed it immediately rolled it's self up into about a 48" diameter roll. So I tried rolling it up the other way. In the mean time I bought another piece of laminate so that I could finish the project and forgot about the roll, left in the garage where it did get hot that summer. When I unrolled it the c enter part was reversed rolled and the ends wanted to roll the other way, I now had a roller coaster for hot wheel cars. When I glued it down I put another sheet of MDF on top and put weights on it and left it for a few days. It never really wanted to lay flat and after a year or so was puckered up in places.

    The place where I bought it had it on a roll that was about 4" in diameter in the center they would spool off the length you wanted and after cutting it roll it in the other direction, when I asked was told to lay it flat as soon as possible and store it flat. I wished that I had asked when I bought the first two pieces.

    So.... in answere to the question, Not Very Long!

    Bill
    over here in the fog, with a high today of about 60 deg.

    Comment

    • chopnhack
      Veteran Member
      • Oct 2006
      • 3779
      • Florida
      • Ryobi BT3100

      #3
      eeep....crap. I have left it for a little over a week now. Tomorrow morning, first thing I will don some gloves and cut the twine, thanks Bill!
      I think in straight lines, but dream in curves

      Comment

      • cabinetman
        Gone but not Forgotten RIP
        • Jun 2006
        • 15216
        • So. Florida
        • Delta

        #4
        If you can't store flat, you can store them on edge. If you have a couple of 4x8 sheets of anything...plywood or melamine, etc, up against the wall, you can slip the mica in between.
        .

        Comment

        • chopnhack
          Veteran Member
          • Oct 2006
          • 3779
          • Florida
          • Ryobi BT3100

          #5
          It worked out well, the pieces layed out pretty flat and I was able to make room to store them like Uncle C. mentioned. Thanks all. I did find a good reference for laminate info, really interesting to see what the industry was saying about using mdf instead of plywood and the reasoning behind the choice!
          http://www.allbusiness.com/furniture.../599224-1.html
          I think in straight lines, but dream in curves

          Comment

          Working...