Gas trimmer problem

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • Salty
    Senior Member
    • Feb 2006
    • 690
    • Akron, Ohio

    #1

    Gas trimmer problem

    Has anyone had a problem with the fuel siphoning from the tank when the trimmer is not running?
    On mine, which is a Homelite and runs great, if I don't loop the blead line so it is above the tank, it will sit there and drip fuel. It seems to be siphoning it from the tank. Is there supposed to be a check valve in the carb to keep that from happening?
    Why doesn't the word 'planing' show up in my computer spell check?
  • Uncle Cracker
    The Full Monte
    • May 2007
    • 7091
    • Sunshine State
    • BT3000

    #2
    I believe most carbs still use a float and valve that shuts off (or is supposed to) the fuel flow to the carb when the bowl is full. Yours may be leaking, or your float may have a hole in its coating which has allowed fuel to soak the float, rendering it ineffective. Or, it could just be that the float is not riding up and down freely. You also might want to consider putting a needle valve shutoff in the fuel line, so you can manually prevent any fuel flow when you are not using the machine.

    Comment

    • wbsettle
      Forum Newbie
      • Mar 2006
      • 92
      • Wilmington, NC
      • BT3100

      #3
      I know it's obvious, but just in case, check all of your fuel line connections.

      I just spent a bit of time fighting leaks after the fuel lines on my 10+ year old US built Ryobi trimmer finally disintegrated. At least on the Ryobi (and the new Troy-Bilt that's replacing it) all of the connections are just friction fits...in/out on the primer bulb, supply line from tank to carb, and tank to primer. The return line from the primer to the tank doesn't even have a gasket where it penetrates the tank...depending instead on the OD of the fuel line to seal the hole.

      I had a hard time getting the replacement lines to seal drip free on the various nipples. Even resorted to trying heat shrink tubing to snug them down a bit. Fuel line starts to melt at about the same temp that activates the heat shrink... In the end, I got the fuel path resealed, but still couldn't get the %!#$ thing to start. Probably a fairly easy fix for someone with the know how, but at $10/year to own/maintain, I'd already spent way too much time trying to fix it, thus the Troy-Bilt. Hopefully, it'll give me at least another 10 years with no extra maintenance costs beyond gas/oil and the occasional spark plug.

      -Brent

      Comment

      Working...