SpinDoctor53
Forum Newbie
Last Activity: 09-30-2026, 11:53 AM
Joined: 09-01-2026
Location:
-
Good example. Only problem I see is if you need the extra height if cutting taller material. For example trying to use the saw as a substitute for a thickness... -
Notes on expanding the table surface.
1) Position the fence rails far enough to the right to allow up to 24" of cutting capacity.
2)...Leave a comment:
-
Finally got the order to go through. If I had access to a mill and a lathe I would make my own. And I would use metric threads as you get more engagement...Leave a comment:
-
I did some checking of the distance from the table to the surfaces the throat plate sits on. The surface the steel throat plates sit on varies about .0010"...Leave a comment:
-
I agree about the potential safety issues. Had one kickback incident close to thirty years ago. Once was enough. Points for consideration.
1) Saw...Leave a comment:
-
t-nuts.com complaint
I ordered some t nuts (1" x 5/16-18) from them. Arrived pretty quick. I've been trying to ode some 1-1/8th w/1/8th hole *.and every time I try l...
No activity results to display
Leave a comment: