For awhile now I've had my router table top on the right side of my saw. I discarded the old table in an attempt to gain some much needed floor space. Well I'm on the verge of getting to use that space for it again.
I have been impressed with what I've seen of the Incra Positioner in YouTube videos and that is the route I'm going. That requires an offset table. I'm hoping I have enough storage room for all the bits, accessories and the other three routers I have. I'm also going to try to have a spot for a dovetail jig like the Leigh D4R if at all possible.
I had originally decided on the PC7518 and Woodpeckers lift, but that was an easy $600. Others have raved about the Triton for table use, so that was the route I went. I picked up the Kreg predrilled plate on Monday and I got the router on Wednesday. I already love the built-in lift. I went with Kreg for the twist insert as well.
The goal is to use this 24x32 table top as the out feed for the saw and, if at all possible, the base for a MFT-style crosscut surface. I'll be looking at a way to drop a surface down on top that I can use the track saw with as well as perhaps the clamps. This of course means the Incra will have to be able to be removed.
I have a rough render on my computer I will post tomorrow. I will start on the top tomorrow, which should be two layers of MDF. Once I have the hole for the plate done, I will have a much more exact layout of everything.
Sent from my HTC One using Tapatalk
I have been impressed with what I've seen of the Incra Positioner in YouTube videos and that is the route I'm going. That requires an offset table. I'm hoping I have enough storage room for all the bits, accessories and the other three routers I have. I'm also going to try to have a spot for a dovetail jig like the Leigh D4R if at all possible.
I had originally decided on the PC7518 and Woodpeckers lift, but that was an easy $600. Others have raved about the Triton for table use, so that was the route I went. I picked up the Kreg predrilled plate on Monday and I got the router on Wednesday. I already love the built-in lift. I went with Kreg for the twist insert as well.
The goal is to use this 24x32 table top as the out feed for the saw and, if at all possible, the base for a MFT-style crosscut surface. I'll be looking at a way to drop a surface down on top that I can use the track saw with as well as perhaps the clamps. This of course means the Incra will have to be able to be removed.
I have a rough render on my computer I will post tomorrow. I will start on the top tomorrow, which should be two layers of MDF. Once I have the hole for the plate done, I will have a much more exact layout of everything.
Sent from my HTC One using Tapatalk
Comment