I had ordered the whatever generation it was SG and additional port, so I have both the 4" and 2.5" ports for the SG. In my cleanup / rearrangement of the shop I found the 4" port in my DC spares. I want to run the big port on it instead of the little one.
It's been years so I just wanted to double check. Do I simply take the side plate off, and slide out / in the port panel and then put the side plate back on?
I could be wrong, but I am figuring especially with the upgrade to 5", the blade guard is REALLY where I want the dust to be picked up from more so than the bottom of the saw...
It's been years so I just wanted to double check. Do I simply take the side plate off, and slide out / in the port panel and then put the side plate back on?
I could be wrong, but I am figuring especially with the upgrade to 5", the blade guard is REALLY where I want the dust to be picked up from more so than the bottom of the saw...
Comment