Is there such a thing as a one or two bit - "bit holder" that attaches to an impact driver somehow or to a drill somehow?
I often use two different drive bits with my impact driver (a Phillips bit and square drive bit, or a Phillips and star drive) when making something, and if I take one out and set it down, it rolls away or gets knocked off of the table, or just plain hides. This frustrates me. Some drills and impact drivers have a very ineffective magnet holder that only work if you don't move the ID.
Have any of you had this problem and Did you solve it?
I am looking for some kind of bit holder that attaches to the impact driver so that the extra bit is WITH the ID or drill during the construction time. I could certainly use this with drill bits also.
I have thought about those rubber key chuck holders but they are made for chuck holder only.
ADDED IN: I have one ID that has a "clip". It does not work well. Short, bits get stuck in it and are hard to retrieve. I mostly use bits 2 inches long or longer. The longer ones stick out of those built in clips and get bumped easily, making the fall out.
Any discussions or recommendations would be appreciated.
I often use two different drive bits with my impact driver (a Phillips bit and square drive bit, or a Phillips and star drive) when making something, and if I take one out and set it down, it rolls away or gets knocked off of the table, or just plain hides. This frustrates me. Some drills and impact drivers have a very ineffective magnet holder that only work if you don't move the ID.
Have any of you had this problem and Did you solve it?
I am looking for some kind of bit holder that attaches to the impact driver so that the extra bit is WITH the ID or drill during the construction time. I could certainly use this with drill bits also.
I have thought about those rubber key chuck holders but they are made for chuck holder only.
ADDED IN: I have one ID that has a "clip". It does not work well. Short, bits get stuck in it and are hard to retrieve. I mostly use bits 2 inches long or longer. The longer ones stick out of those built in clips and get bumped easily, making the fall out.
Any discussions or recommendations would be appreciated.
Comment