Tweet
I purchased a close-quarters ( right angle ) drill off eBay a couple of year ago -- it has actually been quite good. I've sanded lots of bowls with it.. It finally died and I took it apart this afternoon so see if I could get it going again. The sping thing that attaches the trigger to the switch in theI lower portion of the body popped out before I could get a good look at how it was attached.
I was expecting to see a bunch of plastic parts and plastic bushings. This thing is built like a tank. Metal gears and some really nice bearings. I'd really like to get it back together again -
The piece in question has a 5 inch wire, with a 1" angled piece about 30 deg in the xy plane and large 1/2" hairpin on the other end in the z - axis.
I'm not sure which end goes towards the trigger and which end goes towards the switch.
I was expecting to see a bunch of plastic parts and plastic bushings. This thing is built like a tank. Metal gears and some really nice bearings. I'd really like to get it back together again -
The piece in question has a 5 inch wire, with a 1" angled piece about 30 deg in the xy plane and large 1/2" hairpin on the other end in the z - axis.
I'm not sure which end goes towards the trigger and which end goes towards the switch.
Comment