Freud LU85R010 10-Inch Blade

[180x]

Is this a good blade for a SCMS, or would I do better with something else? I have one but I'm debating about exchanging it.

[LinuxRandal]

Generally considered good for the CMS, but as it's a positive hook angle, not considered good for the SCMS.

[Hoover]

The Freud LU91R would be a better choice.

I posted a link to Rockler's web site, for selecting blades last week, but here it is again in case you are interested: http://www.rockler.com/articles/disp...fm?story_id=85

[180x]

Thanks! I think I'm going to order the Freud LU91R010 10'' x 60T.

[Tom Slick]

I run an LU91M on my SCMS and it cuts great. the "M" is a plain blade with no red coating. they are about $48 from amazon.

[180x]

I run an LU91M on my SCMS and it cuts great. the "M" is a plain blade with no red coating. they are about $48 from amazon.

I can't seem to locate the LU91M on Amazon (or Rockler for that matter).

[Tom Slick]

I can't seem to locate the LU91M on Amazon (or Rockler for that matter).

try LU91M010 for the complete part # for a 10" blade

you can try replacing the R in any of the blade part numbers with an M to see if they sell the blade uncoated.

http://www.amazon.com/gp/product/B00...838759-6888744

[180x]

Thanks for the link and the information.