Just for comparison, the 4" ABS Branch Wye, vs a 5" branch wye for folks to get an idea of why I am doing 5"...
And I tidied up the dust collection hoses for the bandsaw...
Now mind you, when the 5" duct goes for the install, I am planning on running the main / branch wye right above where the saw connects / blast gate is, and oriented DOWN, so that will eliminate that 180 degree bend.
Likewise, I was wondering, and the reason I am posting. Is there any thin wall, smooth plastic pipe that I can use for the OE duct location? I am pretty sure I can use a 2.5" 90 to smoothe out the blade shroud connection, but the one just at the lower guide is a LOT of ribbed hose...
And I tidied up the dust collection hoses for the bandsaw...
Now mind you, when the 5" duct goes for the install, I am planning on running the main / branch wye right above where the saw connects / blast gate is, and oriented DOWN, so that will eliminate that 180 degree bend.
Likewise, I was wondering, and the reason I am posting. Is there any thin wall, smooth plastic pipe that I can use for the OE duct location? I am pretty sure I can use a 2.5" 90 to smoothe out the blade shroud connection, but the one just at the lower guide is a LOT of ribbed hose...
Comment