I'm getting into powder coating and I will be needing a receptacle for an oven and for a 240v 30amp air compressor. I don't know if its possible but if I can use one receptacle for both items, one at a time, that is ok (meaning that the plugs are the same).
My main panel is on the side of my garage and inside the garage is another panel (I don't know if its technically called a sub panel). I'm almost out of space but I see one potential option and would like some feedback and confirmation of my thoughts.
Attached is a picture of the panel and the manufactures sticker.
My thought is to replace the 20a 2 pole breaker (red, left side) and go with a quad 2 20a single pole, 1 50a double pole breaker.
https://www.homedepot.com/p/Eaton-BR...2120/302284321
Or I could go with a 2 50a two pole breaker and replace the one 50a breaker on the bottom right.
My main panel is on the side of my garage and inside the garage is another panel (I don't know if its technically called a sub panel). I'm almost out of space but I see one potential option and would like some feedback and confirmation of my thoughts.
Attached is a picture of the panel and the manufactures sticker.
My thought is to replace the 20a 2 pole breaker (red, left side) and go with a quad 2 20a single pole, 1 50a double pole breaker.
https://www.homedepot.com/p/Eaton-BR...2120/302284321
Or I could go with a 2 50a two pole breaker and replace the one 50a breaker on the bottom right.
Comment