Aluminum RollerHolder&Clamper

[Dedpedal]

Has anyone else used this for the rip fence end? Mine was broken when I got it so I gave this a try and found that it works awesomely. See picture below.

[LCHIEN]

Machined aluminum roller holder (part of rear assembly on BT3000 rip fence) I bought one from eBay (Feb 2019) and it works great and I think will definitely outlast the rest of the saw.

I only bought the bracket, the clamper and roller and pins I used from my old one. Hopefully the plastic roller wheel will not break!

https://www.amazon.com/Generic-Rolle...034897&sr=8-33

eBay is showing some right now https://www.ebay.com/sch/i.html?_fro...vice=c&mkcid=2

one bare, and the other with clamper and roller 48 to 68 bucks or so,

A good solution to fixing your rip fence.

[Dedpedal]

I was looking at it today on amazon. I’m thinking about buying another. Hopefully anyone else that is interested can see the number on my pic.

[leehljp]

I bought one also, - I think close to the same time Loring did. It works well!

[GrumpyDad]

Same here. Love it.

[leehljp]

I recently purchased an aluminum Miter Fence holder also:
https://www.ebay.com/itm/Miter-Fence...4AAOSwj0Nercid

Well worth it, IMHO.

[Dedpedal]

I recently purchased an aluminum Miter Fence holder also:
https://www.ebay.com/itm/Miter-Fence...4AAOSwj0Nercid

Well worth it, IMHO.

I looked at that one too but it doesn’t have all the hardware to replace the one I didn’t get when I bought my saw.

[Atonic]

I ordered one from ebay last week. ~$65 + tax+shipping= $75. Cme today and I just installed in. Works fine.

I did have to drill out the holes in the rip fence. Screws were too big. 1/4" bit and done in 3 minutes.

[SAABologist]

I bought one, complete with the clamper since my clamper was gone when I bought the saw. I paid the same for this part as for the entire saw, and feel like it was completely worth is. My rip fence is solid! I also did a repair on the front end of the rip fence to replace the Plate piece. I made a separate thread on that repair.