I'm trying to get my new BT3100-1 dialed in. It had been pretty neglected, and it has probably been through a number of owners. It's coming together, though. The blade goes up and down and tilts nicely, and the motor sounds really good. I did my first cuts, though, and hadn't noticed that the SMT is about 1/8" proud of the main surface. It creates a pretty dangerous situation, that gave me a lot of pause. I think the sliders are setup wrong, but for the life of me, I can't figure out how it should be setup.
Can anyone please tell me where I'm going wrong here? Thanks! -David
Can anyone please tell me where I'm going wrong here? Thanks! -David
Comment