Good morning,
I have a BT3100 and the blade raise and lower mechanism has started to become more difficult during the last several uses. I found in the extensive FAQ document the points to lubricate. However, is there an easy way to gain access to these points. The saw is currently attached to the stand, and getting under there last night made it clear this was going to be more than a 30-minute project to clean and lubricate this.
Does anyone have any tips as to the best way to tune up your saw (e.g. remove from stand and invert on a bench??) ?
Thanks,
Rob
I have a BT3100 and the blade raise and lower mechanism has started to become more difficult during the last several uses. I found in the extensive FAQ document the points to lubricate. However, is there an easy way to gain access to these points. The saw is currently attached to the stand, and getting under there last night made it clear this was going to be more than a 30-minute project to clean and lubricate this.
Does anyone have any tips as to the best way to tune up your saw (e.g. remove from stand and invert on a bench??) ?
Thanks,
Rob
Comment