I had a friend ask me about the difference between stack dado and the other type (wobble ?) name escapes me at the moment - must be my CRS (can’t remember stuff) kicking in again. I have only used a stack dado on my bt3000 with mixed results. I did set up a sacrificial attachment to the rip fence so I could keep the blade away from the rip fence. I used it to cut a rabbett in 1” X 2” trim to make picture frame moulding. I subsequently found it preferable to use my Porte cable router with the accessory table and the ryobi router kit.
Will the wobble router cut a flatter bottom than a stack dado?
what are the pros and cons with each type?
Will the wobble router cut a flatter bottom than a stack dado?
what are the pros and cons with each type?
Comment