Hello, I recently picked up a BT3000. Everything operates as it should including smooth operation of the blade adjusting handle, bevel locking lever etc.... The only issue is that I can grab the blade and "wiggle" it left to right about 1/8th of an inch unless the saw is fully lowered or fully raised. When the saw is all the way up or down there is no play. Does not seem like a shim problem since it raises and lowers very smoothly. The motor is mounted tightly and there is no play in the arbor. Any insight is greatly appreciated since the saw is unsafe/unusable at this point.
Thanks in advance,
Curtis
Thanks in advance,
Curtis
Comment