Tweet
I've just moved my BT3100 to a new shop and thought that I would go through the entire alignment procedure. When I go to align the SMT base to the blade I noticed that there was a gap between the rear silver bar and the rear rail -- that doesn't seem quite right.. The rear rail is attached right side up - I double checked.
As it is now, only the front silver bar on the lower side of the SMT base is in full contact with the black front rail... I noticed that when the rear clamps are pull down tight, the rear rail deflects a bit and takes up the gap between the black rear rail and silver bar on the lower side of the SMT base.
I haven't seen this discussed and the search term would be pretty hard to figure out..
Hints anyone?
As it is now, only the front silver bar on the lower side of the SMT base is in full contact with the black front rail... I noticed that when the rear clamps are pull down tight, the rear rail deflects a bit and takes up the gap between the black rear rail and silver bar on the lower side of the SMT base.
I haven't seen this discussed and the search term would be pretty hard to figure out..
Hints anyone?